Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
DTAFast standalone engine management
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

DTAFast's 30 March 2001 schematic explicitly labels both E48EXP and E48EXP ignition only. The diagram depicts two coil outputs for a wasted-spark example and a 25-position connector. Manufacturer document.

Identification and operating context

This is included for identification as an ignition controller. Record the exact product label, hardware, firmware and loom; do not assume compatibility with a similarly named fuel-and-ignition ECU. See DTAFast family overview.

Wiring

The shared schematic also shows injector connections, but that does not establish working fuel drivers in an ignition-only build. Confirm actual hardware, firmware, pin population and connector orientation with DTAFast. DTAFast wiring reference. Establish fused supplies, grounds, sensor connections and coil-driver limits for the specific unit.

E48EXP 25-way wiring schedule

These assignments are transcribed from the DTAFast E48EXP / E48EXP ignition-only schematic dated 30 March 2001. The document shows the common drawing for both models; do not assume injector output hardware is fitted to an ignition-only unit. Match the precise unit and connector view to the original and check electrical limits. Auxiliary outputs are specified as 500 mA maximum; the drawing requires both power-ground positions connected.

PinFunction shown
1Lambda signal
2Lambda ground
3Gear-shift cut switch
4Launch control switch
55 V sensor supply
65 V sensor supply
7Sensor ground
8Auxiliary 2 output
9Tachometer output
10Fuel-pump relay output
11Gear-change light output
12Battery negative / power ground
13Battery negative / power ground
14Throttle-position wiper
15Water temperature signal
16Air temperature signal
17Pressure sensor signal
18Crank sensor signal (VR)
19Wheel sensor output (Hall)
20Sensor ground / crank sensor return
21Injector 2 or idle valve (fuel-equipped build)
22Injector 1 (fuel-equipped build)
23Coil 2
24Coil 1
25Switched 12 V ECU supply

In the schematic, sensor grounds and 5 V outputs are common within their groups except for the separate lambda ground. The manufacturer also provides differing crank-sensor wire positions for Ford, Bosch/Siemens and Marelli sensors; consult the original diagram and do not assume pin order across sensor makes.