
Model and vehicle application
Syvecs lists this vehicle-specific standalone or plug-in ECU kit as Porsche 996 Turbo S7Plus, with product code S7Plus-99DF. The product page and its stated vehicle, model and transmission details define this particular application; confirm market, model year, engine, ECU connector and transmission against Syvecs before ordering.
This entry describes the dedicated vehicle kit. It is distinct from the generic wire-in ECU: a plug-in kit can use application-specific adaptor wiring, a carrier, additional modules and an application calibration. The listed hardware or supported equipment can vary by revision.
Wiring and pinout
Syvecs Porsche 996 Turbo S7Plus installation and wiring document. Follow the connector orientation, application-specific tables, installation notes and hardware revision in this document. Do not transfer assignments from another vehicle merely because the underlying ECU family is similar. The link was checked to return a PDF.
For other variants and manual revisions consult the manufacturer's vehicle-specific manual index. Available spare inputs and outputs can be used only within their electrical limits and with a matching calibration.
Calibration and service
Use the correct Syvecs software, firmware and base calibration for the exact vehicle and installed hardware. The Syvecs software portal and firmware archive provide manufacturer support. A base map is a starting point and needs checking against the actual engine, injectors, sensors and modifications.
Sources
- Syvecs Porsche 996 Turbo S7Plus product listing and application
- Manufacturer kit installation and pinout manual
- Syvecs plug-in kit support index
Plug-in board 26-way accessory connector
The Syvecs 996/997 Turbo S7Plus manual, version 1.2, lists this accessory connector. It labels terminal 12 AN S6 / Slave An06, skipping S5; that numbering is reproduced as printed. Use the manual and actual board to identify orientation, ratings and ECU revision. This is not the full OEM loom connector pinout.
| Pin | Manufacturer function |
|---|---|
| 1 | Ground |
| 2 | Fuel 7 |
| 3 | Fuel 8 |
| 4 | Fuel 9 |
| 5 | Fuel 10 |
| 6 | Fuel 11 |
| 7 | Fuel 12 |
| 8 | AN S1 / Slave An01 |
| 9 | AN S2 / Slave An02 |
| 10 | AN S3 / Slave An03 |
| 11 | AN S4 / Slave An04 |
| 12 | AN S6 / Slave An06 |
| 13 | 12 V |
| 14 | CAN2 low |
| 15 | CAN2 high |
| 16 | EGT1− |
| 17 | EGT1+ |
| 18 | RS232 RX |
| 19 | RS232 TX |
| 20 | Sensor ground |
| 21 | 5 V |
| 22 | LAM2C |
| 23 | LAN RX− |
| 24 | LAN RX+ |
| 25 | LAN TX− |
| 26 | LAN TX+ |