Autronic SM3 is a standalone or earlier programmable engine-management system. SM3 is described by Autronic as a third-generation ECU with six injector and four ignition outputs. Model-specific information.
Identification and features
Record the ECU label, model, part number, hardware revision, firmware, configured injectors, ignition hardware and loom before comparing systems. Some outputs can be reassigned; hardware, software, current limits and engine-specific options determine what is actually available.
Wiring and pinout
Consult the Autronic SM3 wiring and documentation source and identify the exact connector face, part and version. Do not apply wiring from a similarly named model. If an exact drawing is unavailable for the unit at hand, obtain it from the manufacturer or supplier before making connections.
Further information
SM3 standard loom connector
These 42 positions are transcribed from Autronic SM3 standard loom drawing SM3_0001 revision 1.1. Autronic's wiring index says the drawing also suits SM3 Marine. Connector view is from the wire side. Check the original for wire colours, shared functions, grounding and output limits. The drawing specifies saturated injector drivers and requires ballast for low-impedance injectors, with a minimum 5-ohm load per output.
| Pin | Function in drawing |
|---|---|
| 1 | Ground |
| 2 | +12 V RAM supply |
| 3 | Injector output 3 |
| 4 | Injector output 2 |
| 5 | Ignition output 4 |
| 6 | Output 2 / stepper |
| 7 | Output 4 / stepper |
| 8 | Sensor +5 V supply |
| 9 | Oxygen sensor input |
| 10 | Analogue input 2–3 |
| 11 | HSI input 3 |
| 12 | Cylinder trigger − |
| 13 | Sync trigger − |
| 14 | Output 7 |
| 15 | +12 V supply |
| 16 | Injector output 4 |
| 17 | Injector output 1 |
| 18 | Injector output 6 / switch input 1 |
| 19 | Ignition output 3 |
| 20 | Output 3 / stepper |
| 21 | Throttle position input |
| 22 | Sensor ground |
| 23 | Air temperature input |
| 24 | HSI input 2 |
| 25 | Cylinder trigger + |
| 26 | Sync trigger + |
| 27 | Output 5 |
| 28 | PWM output 1 |
| 29 | Ignition switch input |
| 30 | Switch input 3 |
| 31 | Switch input 2 |
| 32 | Injector output 5 |
| 33 | Ignition output 1 |
| 34 | Ignition output 2 |
| 35 | Output 1 / stepper |
| 36 | Analogue input 1 |
| 37 | Coolant temperature input |
| 38 | HSI input 1 |
| 39 | +8 V trigger supply |
| 40 | Output 8 / tachometer |
| 41 | Output 6 |
| 42 | PWM output 2 |