MSPNP-Pro EECV-8PM is a vehicle-specific MS3Pro-based plug-in engine management ECU. The manufacturer’s model-specific installation guide lists the following application: 1999–2003 Mazda Protegé 1.6, 1.8, 2.0 and 2.0T, manual transmission, as listed by the guide. Fitment depends on the original ECU connector, engine, harness and market; confirm the exact part number before installation.
Application and installation
The manufacturer’s document title and index say EECV-8PM, but the opening model identifier says EECV-4PM. Treat the code as unresolved and verify the label and fitment with the supplier. Plug-in does not mean every optional feature is prewired: follow the relevant guide for setup, sensors, jumpers, base tune and ignition-timing checks.
Pinout and documentation
AMP EFI EECV-8PM vehicle-specific installation and connector documentation is the primary source for this model. Check the connector orientation, version and any configurable or optional functions before wiring. Diagrams may be shown as images in the guide; this page does not substitute a pin assignment from another MSPNP model.
See the manufacturer’s ECU documentation index and firmware and base-tune index. Initial maps require verification and tuning for the particular engine.
Rear options connector — A–Z
Transcribed from this application's AMP EFI installation guide. These are the rear options connections; they are not the complete factory vehicle connector pinout. Verify orientation, exact ECU variant, electrical limits and software configuration before wiring.
| Pin | Function | Default or note in source |
|---|---|---|
| A | Analog sensor ground | Sensor return |
| B | 5 V Vref | Fused at 250 mA |
| C | AIN2 | Fuel level sensor; duplicates main pin 63 |
| D | 12 V supply out | Fused at 250 mA |
| E | IAT | Duplicates main pin 39 |
| F | External MAP sensor | Internal MAP sensor default |
| G | EGO | Optional wideband O2; duplicates main pin 60 |
| H | Analog input 1 | MAF sensor; duplicates main pin 88 |
| I | CANL | — |
| J | DFIN1 conditioned | VR sensors only; duplicates main pin 58 |
| K | CANH | — |
| L | DFIN2 conditioned | Additional speed sensor, VR sensors only |
| M | Digital input 1 | Optional flex fuel |
| N | Digital input 4 | — |
| O | Digital input 2 | — |
| P | DFIN3 | — |
| Q | Digital input 3 | A/C request switch; duplicates main pin 41 |
| R | Tach out | Instrument cluster; duplicates main pin 48 |
| S | Power ground | — |
| T | High current output 3 | VICS; duplicates main pin 19 |
| U | High current output 1 | Condenser fan; duplicates main pins 17 and 45 |
| V | High current output 2 | Duplicates main pin 82 |
| W | PWM output 3 | A/C compressor; duplicates main pin 69 |
| X | Injector output J | Charge lamp; duplicates main pin 42 |
| Y | PWM output 2 | High cooling fan; duplicates main pin 46 |
| Z | Injector output I | High impedance only |