Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MBE Systems standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The MBE 967i is an older ignition-oriented controller with its own wiring instructions. SBD archives separate standard and D-driven installation sheets; confirm the ignition drive variant before using them. Source and identification.

Wiring and pinout

Model wiring documentation: 967i series wiring instruction; the archive separately lists a D-driven version. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.

Configuration and support

For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.

Evidence limits

Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.

Four-way interface connector

The SBD 967i series wiring instruction, January 2014 lists the following four interface Sure Seal positions. This is the documented interface, not a complete internal ECU connector pinout. The supply pins are connected through the shown ignition-switched relay; follow the original relay diagram and verify the actual unit and wiring colours.

PinGuide wire colourGuide function
1Purple or orange12 V battery supply via relay
2White or red12 V battery supply via relay
3Grey or yellowGearshift-light earth trigger
4Green or blueRev counter

The same instruction lists white/black as ignition drive 1, white as 12 V and white/green as ignition drive 2 on the illustrated ignition lead. Its separate D-driven variant must be identified independently.