Adaptronic M1200 is a standalone or earlier programmable engine-management system. Modular M1200 universal wire-in ECU; Haltech retains a model-specific startup guide, pinout and basemap. Its 26-way connector diagram identifies four injectors; high-impedance injectors are specified in that diagram. Model-specific information.
Identification and features
Record the ECU label, model, part number, hardware revision, firmware, configured injectors, ignition hardware and loom before comparing systems. Some outputs can be reassigned; hardware, software, current limits and engine-specific options determine what is actually available.
Wiring and pinout
Consult the Adaptronic M1200 wiring and documentation source and identify the exact connector face, part and version. Do not apply wiring from a similarly named model. If an exact drawing is unavailable for the unit at hand, obtain it from the manufacturer or supplier before making connections.
Further information
Manufacturer connector pinouts
Transcribed from the Adaptronic M1200 wiring diagrams in Haltech's archive. The source marks optional functions in red; optionality is noted below. The drawing says pins 1A, 2I and 2S must not be connected. The 26-way injector outputs are specified for high-impedance injectors, 2 A maximum. The diagrams require external ignition drivers or coils with built-in igniters; see the source for wiring orientation, wire colours, current limits, power supplies and ECU configuration.
22-way connector
| Pin | Function in drawing |
|---|---|
| 1A | Do not connect |
| 1B | Ignition +12 V |
| 1C | Servo (optional) |
| 1D | Auxiliary 2 |
| 1E | Auxiliary 5 |
| 1F | Ignition 3 |
| 1G | Ignition 1 |
| 1H | Ignition 2 |
| 1I | CAN low (optional) |
| 1J | Auxiliary 3 |
| 1K | CAN high (optional) |
| 1L | Auxiliary 6 |
| 1M | Vehicle speed sensor |
| 1N | Fuel pressure (optional) |
| 1O | Digital input 3 (optional) |
| 1P | Digital input 1 (optional) |
| 1Q | Digital input 2 (optional) |
| 1R | Auxiliary 7 |
| 1S | Digital input 4 (optional) |
| 1T | Ignition 4 |
| 1U | TPS 2 (optional) |
| 1V | Fuel temperature (optional) |
26-way connector
| Pin | Function in drawing |
|---|---|
| 2A | Power ground |
| 2B | Power ground |
| 2C | Sensor ground |
| 2D | Sensor ground |
| 2E | CAS 1 |
| 2F | CAS 3 (optional) |
| 2G | CAS 2 (optional) |
| 2H | Oil temperature (optional) |
| 2I | Do not connect |
| 2J | Knock (optional) |
| 2K | 5 V sensor supply |
| 2L | Oil pressure (optional) |
| 2M | Throttle position |
| 2N | Oxygen 1 (optional) |
| 2O | IMAP / external MAP input (optional) |
| 2P | Manifold air temperature |
| 2Q | Coolant temperature |
| 2R | Tachometer (optional) |
| 2S | Do not connect |
| 2T | ECCS / EFI / fuel pump relay output |
| 2U | Injector 1 |
| 2V | Injector 4 |
| 2W | Auxiliary 1 |
| 2X | Auxiliary 4 |
| 2Y | Injector 2 |
| 2Z | Injector 3 |