Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MBE Systems standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The MBE 967 belongs to the earlier serial ECU generation. SBD archives a model-specific connector pinout; a separate 967i ignition-only wiring instruction exists and should not be assumed identical. Source and identification.

Wiring and pinout

Model wiring documentation: MBE967 pinout information. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.

Configuration and support

For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.

Evidence limits

Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.

Complete documented 36-way connector

These positions come from the MBE 967e connection list dated 30 March 2000; the source specifically identifies 967e, so verify the exact build before using it for another 967 variant. Verify the connector view, programmable input/output configuration, coil driver type and electrical limits in the original.

PinDesignationSource note
1FUEL TRIMMapping Plug 06
2WATER TEMPERATURE SIGNAL
3AIR TEMPERATURE SIGNAL
45V ANALOGUEMapping Plug 04
5ANALOGUE GROUNDMapping Plug 05
6POWER GROUNDMapping Plug 01
7POWER GROUND
8POWER GROUND
9POWER GROUND
10FUEL PRESSURE INPUT/GEAR POSITION
11CRANK RETURN
12CRANK SIGNAL
13ECU SUPPLY
14SERIAL RECEIVEMapping Plug 03
15FAULT LIGHT / SWITCH
16SHIFT LIGHTSwitched Ground
17FUEL PUMP RELAY DRIVESwitched Ground
18IGNITION DRIVE 2Cylinders 2 + 3 Not used if distributor fitted
19POWERSHIFT INPUTGround Active
20THROTTLE SIGNAL
21MAP SIGNAL (BOOST PRESSURE)
225V ANALOGUE
23ANALOGUE GROUND
24ANALOGUE GROUND
25OIL TEMPERATURE
26IGNITION TRIMMapping Plug 07
27OIL PRESSURE
28BAROMETRIC PRESSURE SIGNAL / LAUNCH INPUT
29LAMBDA SIGNAL
30NOT USEDNot Used
31NOT USEDNot Used
32SERIAL TRANSMITMapping Plug 02
33RADIATOR FAN RELAY DRIVESwitched Ground
34TACHOMETER SIGNAL
35INJECTOR OUTPUTAll Cylinders
36IGNITION DRIVE 1Cylinders 1+ 4 Coil drive if distributor fitted