The 9M4i is an ignition-only controller for up to four cylinders, not a fuel-injection ECU. SBD describes four configurable ignition drives and says it supersedes the 9A4i with the same pinouts and instructions. Source and identification.
Wiring and pinout
Model wiring documentation: 9A4i diagram linked on the 9M4i product page. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.
Configuration and support
For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.
Evidence limits
Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.
Complete documented 36-way connector
These positions are from SBD's 9A4i 36-way pin list. SBD's 9M4i product page says the 9M4i uses the same pinouts and instructions as the 9A4i. Both are ignition-only models. Verify the connector view, programmable input/output configuration, coil driver type and electrical limits in the original.
| Pin | General function |
|---|---|
| 1 | N/A |
| 2 | Water Temp |
| 3 | Air Temp |
| 4 | 5VA Ref |
| 5 | 0VA |
| 6 | Power Ground |
| 7 | Power Ground |
| 8 | CANL |
| 9 | CANH |
| 10 | Permanent 12V Supply (Battery) |
| 11 | Crank Return |
| 12 | Crank Signal |
| 13 | Switched 12V Supply (Key) |
| 14 | N/A |
| 15 | Ignition D (4th to fire) |
| 16 | Programmable Low Side Output Pin* |
| 17 | Programmable Low Side Output Pin* |
| 18 | Ignition B (2nd to fire) |
| 19 | Programmable Input Pin* |
| 20 | TPS |
| 21 | MAP |
| 22 | 5VA Ref |
| 23 | 0VA |
| 24 | 0VA |
| 25 | Programmable Input Pin* |
| 26 | N/A |
| 27 | Programmable Input Pin* |
| 28 | Baro |
| 29 | N/A |
| 30 | Cam Signal |
| 31 | Cam Return |
| 32 | N/A |
| 33 | Programmable Low Side Output Pin* |
| 34 | Programmable Low Side Output Pin* |
| 35 | Ignition C (3rd to fire) |
| 36 | Ignition A (1st to fire) |