The 9A6 is a direct-injection ECU for four-cylinder engines; SBD developed its documented application for the Ford 1.6-litre EcoBoost. SBD also identifies twin CAN buses and wideband inputs. Direct-injector and throttle control depend on exact application and configuration. Source and identification.
Wiring and pinout
Model wiring documentation: 9A6 pinout issue F, not the 9A9 connector assignment. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.
Configuration and support
For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.
Evidence limits
Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.
Complete connector assignments
All 121 labelled positions follow the SBD 9A6 connection list, issue F, BOM 0.1, software f192 onward. The table reproduces the source's pin titles; “not named” indicates an empty title, not necessarily an unused circuit. Consult the original for output ratings, pull-ups, individual notes and connector orientation. Assigned functions depend on calibration and particular hardware.
| Pin | Manufacturer connection-list title |
|---|---|
| A001 | Ground |
| A002 | Ground |
| A003 | ECU Permanent 12V Supply |
| A004 | 12V Switch |
| A005 | 12V Switch |
| A006 | Air Charge Pump Relay |
| A007 | Oil Temp |
| A008 | Injector A+ |
| A009 | Anti Lag Signal |
| A010 | Baro Signal |
| A011 | 5Va2 |
| A012 | Injector A- |
| A013 | Narrow Band Oxygen Sensor 1 |
| A014 | 5Va1 |
| A015 | Lambda1 R |
| A016 | Cam Return |
| A017 | EGT Signal |
| A018 | Air Temp Signal |
| A019 | Not named in source |
| A020 | 0Va |
| A021 | Malfunction Indicator Lamp (MIL) |
| A022 | Wastegate Drive |
| A023 | Rad Fan 1 |
| A024 | Fuel Pump Relay |
| A025 | Shift Up Solenoid |
| A026 | Launch Signal |
| A027 | Injector C+ |
| A028 | Engine Oil Pressure |
| A029 | Lambda1 N |
| A030 | 5Va2 |
| A031 | Injector C- |
| A032 | AC Request |
| A033 | 5Va1 |
| A034 | HP Fuel Signal |
| A035 | Cam Supply |
| A036 | Shift Up |
| A037 | Start Request |
| A038 | TPS2 Signal |
| A039 | 0Va |
| A040 | Electronic Wastegate Actuator Drive - |
| A041 | Electronic Wastegate Actuator Drive + |
| A042 | Lambda Sensor 2 Heater |
| A043 | Lambda Sensor 1 Heater |
| A044 | Shift Down Solenoid |
| A045 | Pedal A Signal |
| A046 | Injector B+ |
| A047 | TPS1 Signal |
| A048 | Lambda1 VG |
| A049 | Lambda1 P |
| A050 | Injector B- |
| A051 | Engine Stop Signal |
| A052 | 5Va1 |
| A053 | Gearbox Signal |
| A054 | Cam 2Signal |
| A055 | Pedal B Signal |
| A056 | Not named in source |
| A057 | Electronic Waste Gate (TPS4) Signal |
| A058 | 0Va |
| A059 | Egas1 Motor Drive - |
| A060 | Egas1 Motor Drive + |
| A061 | HP Fuel Pump Drive |
| A062 | Shift Down |
| A063 | Rad Fan 1 Relay |
| A064 | Air Accumulator Pressure |
| A065 | Injector D+ |
| A066 | MAP |
| A067 | Water Temp Signal |
| A068 | LP Fuel Signal |
| A069 | Injector D- |
| A070 | Boost Limit |
| A071 | 5Va1 |
| A072 | Neutral Request |
| A073 | Cam1 Signal |
| A074 | Electronic Waste Gate (TPS3) Signal |
| A075 | Clutch Voltage |
| A076 | Nitrous Input Pin |
| A077 | 0Va |
| A078 | Engine Stop Output |
| A079 | Inlet Cam Drive (Cam 1) |
| A080 | Exhaust Cam Drive (Cam 2) |
| A081 | Tachometer Drive |
| B082 | Upper Injector H |
| B083 | 5Va2 |
| B084 | WS3+ |
| B085 | Knock1 Signal |
| B086 | WS1+ |
| B087 | MAF Signal |
| B088 | CAN2 H |
| B089 | CAN H |
| B090 | Upper Injector G |
| B091 | 5Va2 |
| B092 | WS4+ |
| B093 | Knock1 Return |
| B094 | WS2+ |
| B095 | PWM Pedal |
| B096 | CAN2 L |
| B097 | CAN L |
| B098 | Upper Injector F |
| B099 | 5Va1 |
| B100 | Crank Signal |
| B101 | Knock 2 Signal |
| B102 | WS1 Return |
| B103 | WS2 Return |
| B104 | WS3 Return |
| B105 | WS4 Return |
| B106 | Upper Injector E |
| B107 | 5Va1 |
| B108 | Crank Return |
| B109 | Knock 2 Return |
| B110 | Ignition Drive A |
| B111 | Ignition Drive B |
| B112 | Ignition Drive C |
| B113 | Ignition Drive D |
| B114 | HSD Battery + |
| B115 | HSD Battery + |
| B116 | Starter Solenoid Drive |
| B117 | Ignition Output HSD |
| B118 | PWM Water Pump |
| B119 | n/c |
| B120 | Fuel Pump HSD |
| B121 | n/c |