Earlier programmable injection and ignition controller; the Portuguese manufacturer manual describes distributor ignition, injector wiring, auxiliary outputs and model-specific trigger arrangements. FuelTech primary source.
Identification and wiring
Record the precise controller and hardware before wiring. The original installation document must be matched to the unit and connector; no pin assignments are inferred from later FuelTech models. FuelTech Portuguese manuals index · English manuals.
See FuelTech ECU family. Sources reviewed 17 November 2026.
24-way main harness connector
Translated from the FuelTech FT200 installation manual in Portuguese, section 4.1. Establish orientation from the source and match the ECU revision. Ignition outputs B–E are marked unused on the FT200. The FT200 grounding instructions differ from those of some later FuelTech ECUs; consult its original documentation rather than transferring a later model’s scheme.
| Pin | Function and harness wire |
|---|---|
| 1 | Tachometer output (green) |
| 2 | Auxiliary output 3 (yellow 3) |
| 3 | Intake air temperature input (white/blue) |
| 4 | Auxiliary output 2 (yellow 2) |
| 5 | Fuel or oil pressure input (white) |
| 6 | Auxiliary output 1 (yellow 1) |
| 7 | Coolant temperature input (pink) |
| 8 | Auxiliary output 4 (yellow 4) |
| 9 | Fuel/oil pressure or two-step input (blue) |
| 10 | Not used (gray E) |
| 11 | Throttle position signal (orange) |
| 12 | Not used (gray D) |
| 13 | MAP signal output (yellow/red) |
| 14 | Not used (gray C) |
| 15 | Original MAP/MAF signal clamper (green/yellow) |
| 16 | Not used (gray B) |
| 17 | RPM signal input (shielded cable) |
| 18 | Ignition output A (gray A) |
| 19 | Battery negative / signal ground (black) |
| 20 | 5 V sensor supply (green/red) |
| 21 | Switched 12 V supply (red) |
| 22 | Chassis power ground (black/white) |
| 23 | Fuel injector bank B negative (brown) |
| 24 | Fuel injector bank A negative (purple) |