Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
FuelTech standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None
FuelTech FT300
FuelTech FT300. Image: manufacturer product page; permission to republish confirmed by user.

FuelTech FT300 is a Earlier FT generation engine-management unit. Earlier programmable fuel and ignition system; the paired FT250/FT300 manual documents model-specific ignition and harness setup. FuelTech model documentation · FuelTech range comparison.

Identification and software

Record the exact model, serial, harness, firmware and configured outputs; similarly named FT models may use different connectors and functions. Tuning software: ECU Manager / Datalogger (earlier generation). FuelTech software and compatibility.

Wiring and pinout

Use the model-specific manual and the current FuelTech manuals index for connector view, cavity numbering, fuse values, sensor grounds and injector-driver limits. The manufacturer wiring archive contains installation-specific examples; match the exact ECU and harness before wiring. Pin functions depend on the model, hardware and configured output.

See FuelTech engine-management family for other models and company background. FuelTech is based in Brazil and has a US operation in Georgia. Sources reviewed 17 November 2026.

Features and identification

FuelTech Brazil lists a two-line OLED display, two injector outputs controlling up to twelve high-impedance injectors in up to two banks, and five ignition outputs. The ECU can be mapped at the unit or through ECU Manager with a USB-CAN converter. Trigger input arrangements differ for certain installations, so confirm whether the unit has the required differential input modification. FuelTech FT300 product specification.

24-way main connector

Pin numbers and wire functions below follow FuelTech's FT250 / FT300 manual, section 5.1; view the connector from the harness rear as shown in section 5.2. The FT250 uses only ignition output A; E, D, C and B are marked unavailable on FT250. The FT300 supports the additional ignition outputs. Check the actual configuration, sensor wiring, ignition driver and ground instructions.

PinFunction and harness wire
1Tachometer output (green)
2Auxiliary output 3 (yellow 3)
3Intake air temperature input (white/blue)
4Auxiliary output 2 (yellow 2)
5Fuel/oil pressure or lambda input (white)
6Auxiliary output 1 (yellow 1)
7Coolant temperature input (pink)
8Auxiliary output 4 (yellow 4)
9Fuel/oil pressure or two-step input (blue)
10Ignition output E (gray E)
11Throttle position signal (orange)
12Ignition output D (gray D)
13MAP signal output (yellow/red)
14Ignition output C (gray C)
15Cam sync / FT250 MAP–MAF clamper, see note (green/yellow)
16Ignition output B (gray B)
17RPM signal input (shielded cable)
18Ignition output A (gray A)
19Battery negative / signal ground (black)
205 V sensor supply (green/red)
21Switched 12 V supply (red)
22Power / chassis ground (black/white)
23Fuel injector bank B negative (brown)
24Fuel injector bank A negative (purple)

FT250 source ambiguity: the wiring table identifies pin 15 as the MAP/MAF clamper connection for FT250, while the figure note appears to describe pin 13 as the clamper. Confirm the exact FT250 harness and corrected guidance with FuelTech before connecting this function.