Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MoTeC standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

MoTeC M4, part 11001, is an earlier Gold Box engine controller listed in MoTeC's obsolete-product archive. The manufacturer manual describes four injector groups and gives examples for six-, eight- and twelve-cylinder engines using injectors wired in groups; this is not a claim of separate sequential outputs for each cylinder. Manufacturer Gold Box archive; manufacturer model glossary.

Identification and compatibility

Read the full ECU part number, connector, firmware, options and the label before identifying the correct model. Configurations and optional engine packages vary; a similar suffix, physical plug or a common calibration does not establish a universal pinout or exact cylinder capability. The manufacturer's archived product listing provides M4-specific documentation.

Pinout and software

Consult the MoTeC M4 product and wiring downloads and MoTeC legacy downloads. Model and marine-labelled variants must be checked against their own part numbers, connector drawings and firmware. Confirm connector orientation and the complete power, ground, sensor, injector and ignition circuits with the original documentation before wiring.

These units use a legacy ECU Manager or EMP software generation appropriate to the exact controller and firmware; M1 Tune is for M1 products. See MoTeC software archive and the MoTeC manufacturer guide.

Manufacturer wiring diagram pinout

Transcribed from the M4 ECU wiring drawing on printed page 55 of the MoTeC M4/M48/M8 user manual. The model-specific drawing and ECU connector view define the orientation. Shared ignition and auxiliary or digital-input functions depend on the configuration. Pins described only by the PC connector connection are identified that way; do not assume their signalling standard. Check hardware revision, electrical loads and trigger wiring against the original.

36-way connector

PinFunction in manufacturer drawing
1Battery positive
2Injector 1
3Injector 2
4Sensor 5 V
5REF Hall / optical
6REF magnetic
7SYNC Hall / optical
8SYNC magnetic
9PC/calibrator D9 pin 6
10PC/calibrator D9 pin 9
11PC/calibrator D9 pin 5
12PC/calibrator D9 pin 7
13Auxiliary 1
14Injector 3
15Injector 4
16Throttle position
17Manifold pressure
18Auxiliary voltage
19Digital input 1
20Digital input 2
21PC/calibrator D9 pin 2
22PC/calibrator D9 pin 3
23PC/calibrator D9 pin 4
24PC/calibrator D9 pin 1
25ECU power ground
26Sensor 8 V
27Sensor 0 V
28Engine temperature
29Air temperature
30Auxiliary temperature
31Lambda +
32Lambda −
33Ignition 1
34Auxiliary 2 / ignition 2
35Auxiliary 3 / ignition 3
36Auxiliary 4 / ignition 4