
Ocelot is an independently designed WTMtronics Speeduino-compatible board following UA4C, with an integrated microcontroller and automotive connector. The designer also lists a vehicle-speed input, flyback diodes and reset button. Its project notes distinguish it from a UA4C using a separate Arduino.
Revision and connections
Use the Ocelot designer documentation and schematic directory for the exact board. The designer’s overview and errata reports that revision A3 primary and secondary trigger jumper labels are reversed. Confirm the actual board and firmware rather than using a UA4C or v0.4 connector diagram.
48-position harness connector
The following is from WTMtronics' Ocelot connector mapping. Terminal numbers follow the manufacturer drawing; the Arduino column identifies the microcontroller pin and is not the harness terminal number. All outputs except ignitors and stepper idle are ground-switching; the source calls for at least two ground terminals to a single ground source. Verify connector view, hardware revision and trigger jumpers against the original.
| Connector terminal | Function | Arduino pin |
|---|---|---|
| 1 | GPI | |
| 2 | GPO | |
| 3 | Spare input 1 | A8 |
| 4 | Spare input 2 | A9 |
| 5 | 5 V output | |
| 6 | Keyed 12 V input | |
| 7 | Ground | |
| 8 | Stepper idle A2 | |
| 9 | Stepper idle B1 | |
| 10 | Unswitched 12 V input (flyback for idle, boost and VVT) | |
| 11 | Low-current output 4 | D29 |
| 12 | VVT | D11 |
| 13 | Boost | D12 |
| 14 | PWM idle 2 | D10 |
| 15 | PWM idle 1 | D9 |
| 16 | Injector 4 | D5 |
| 17 | Exhaust gas sensor | A1 |
| 18 | Throttle position sensor | A3 |
| 19 | Coolant temperature sensor | A4 |
| 20 | Flex fuel sensor | D20 |
| 21 | Secondary trigger (VR− only) | |
| 22 | Primary trigger (VR− only) | |
| 23 | Ground | |
| 24 | Ground | |
| 25 | Stepper idle A1 | |
| 26 | Ignitor 4 | D34 |
| 27 | Ignitor 3 | D33 |
| 28 | Low-current output 3 | D28 |
| 29 | Low-current output 2 | D27 |
| 30 | Fan 2 | D25 |
| 31 | Tachometer | D22 |
| 32 | Injector 3 | D6 |
| 33 | Inlet air temperature sensor | A5 |
| 34 | Launch/clutch | D37 |
| 35 | Vehicle speed sensor | D2 |
| 36 | Knock sensor | D21 |
| 37 | Secondary trigger | D18 |
| 38 | Primary trigger | D19 |
| 39 | Ground | |
| 40 | Ground | |
| 41 | Stepper idle B2 | |
| 42 | Ignitor 2 | D36 |
| 43 | Ignitor 1 | D35 |
| 44 | Low-current output 1 | D26 |
| 45 | Fan 1 | D24 |
| 46 | Fuel pump | D23 |
| 47 | Injector 2 | D7 |
| 48 | Injector 1 | D8 |