Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Engine ECU
Parent
Speeduino standalone ECUs
Applies to
Speeduino standalone ECUs
Tool groups
None
Manufacturers
None
WTMtronics NO2C Speeduino-compatible board
WTMtronics NO2C product image. Source: WTMtronics; reproduced with permission. Board revisions and kit contents may vary.

NO2C (No Overhang Two Channel) is an independently designed WTMtronics board using Speeduino firmware, not an official Speeduino project board. The designer documents two injector channels, two ignitor channels, VVT, PWM idle, boost, fuel-pump and tachometer outputs, two triggers, launch, CLT, IAT, TPS and O2 inputs, MAP and a socket for a stepper-idle module.

Versions and wiring

The designer’s NO2C revision files and project-hosted NO2C revision guide distinguish v0.1.x, v0.2.x, C1 and D1. The guide notes different connector families between v0.1 and v0.2. Obtain the schematic for the physical revision; do not substitute the 40-way v0.4 pinout. A board layout setting and firmware version must also match.

Connector assignments — NO2C vD1

The tables transcribe schematic connector labels from WTMtronics' NO2C vD1 schematic, sheet 1. These schematic position numbers must be matched to the PCB and mating connector orientation; other NO2C revisions and panel-mount wiring can differ. Check the trigger conditioner, output drivers and circuit ratings for the actual assembly.

P1 main 24-way

Schematic pinFunction
1+BATT
2Ground
3Ground
4Ground
5VVT
6Idle
7Fuel pump
8Injector 1
9Injector 2
10Boost
11Ignition 1
12Ignition 2
13Launch
14Ground
15+5 V
16O2
17TPS
18Coolant temperature
19Intake air temperature
20VR1+
21VR1−
22VR2+
23VR2−
24Tachometer

P2 stepper idle

Schematic pinFunction
1Stepper A2
2Stepper A1
3Stepper B1
4Stepper B2

P3 daughter-board power

Schematic pinFunction
1+12 V
2Ground
3Ground
4+5 V

P4 Bluetooth header

Schematic pinFunction
1TX0
2RX0
3Ground
4+5 V