Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
ECUMaster EMU Black
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None
ECUMaster EMU Black Lotus 2ZZ-GE plug-in ECU
ECUMaster EMU Black Lotus 2ZZ-GE plug-in. Product photo: ECUMaster plug-in ECU catalogue; reproduced with permission.

The manufacturer catalogue specifies the drive-by-wire Lotus 2ZZ-GE plug-in. Manual v2.0 is for EMU Black software 2.169 or later and documents naturally aspirated and supercharged variants, OEM CAN, variable valve lift and timing, and a stock 2ZZ base map. Actual installation depends on the engine and car specification. Model source · ECUMaster plug-in catalogue.

Wiring and pinout

The manual's page 8 describes wideband signal connections at the OEM Lotus connector. The following are the ECU terminal labels, not sensor connector pin numbers. The source gives separate Bosch LSU 4.2 and 4.9 sensor-side mappings and instructs disconnection of the OEM narrowband sensor when fitting wideband. Manufacturer model-specific document.

TerminalDocumented function
3KWideband heater
4EWideband Ip
3AWideband Vs
3DWideband Rcal
4FWideband VGnd
3G+12 V

Spare factory terminals — manual v2.0

The manufacturer's spare-I/O table lists these positions on otherwise unused OEM ECU terminals. This is not a complete factory connector pinout.

ECU terminalManual function
1GEGT input 1
2CRS232 TX
3CRS232 RX
3DWideband Rcal
3FEGT input 2
4EWideband Ip
4FWideband VGnd
3AKnock sensor input 2 (source conflicts; see below)
3LFlex fuel input

Conflicting source: The same manual assigns terminal 3A to wideband Vs in its wideband wiring table and knock sensor input 2 in the spare-I/O table. Confirm the correct assignment with ECUMaster for the specific ECU before wiring.

Wideband connector mapping

Sensor-side terminals differ between LSU 4.2 and 4.9. The manual directs that the original narrowband sensor be disconnected before installing a wideband.

ECU terminalFunctionLSU 4.2 terminalLSU 4.9 terminal
3KHeater43
4EIp61
3AVs (conflicts with spare-I/O table)16
3DRcal25
4FVGnd52
3G+12 V34

Calibration and fitment checks

Record the engine code, ECU label and hardware, factory wiring and software version. The manufacturer provides software, available application notes and base maps; a base map is a starting point requiring checks of sensor readings, throttle operation, injector and ignition settings, trigger timing and engine calibration. Do not transfer universal EMU Black pin numbers or another plug-in's auxiliary connector assignments to this unit.

See the EMU Black model page and manufacturer index.

Other 2ZZ arrangements

The ECU manual lists separate CAN dashboard settings for 2ZZ electronic throttle, cable throttle and Lotus S3 2ZZ; a selectable software mode alone does not prove that one physical plug-in ECU fits every harness. RRR separately sells a Lotus S2 2ZZ cable-throttle adapter kit using an EMU Black. Identify the kit and adapter maker and obtain the matching wiring instructions; it is not established to be the same integrated ECU as the ECUMaster DBW plug-in.