Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MBE Systems standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The 9A9 is an MBE fuel-injection ECU for up to eight cylinders. SBD describes twin wideband lambda inputs and two CAN buses; pinout, sensor and driver suitability depends on the exact hardware and software. Source and identification.

Wiring and pinout

Model wiring documentation: Issue N2, BOM1-010 onward only; obtain the matching diagram for other builds. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.

Configuration and support

For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.

Evidence limits

Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.

Selected connector pins

The following is a partial reference for 9A9 issue N2; BOM 1.010 or later and software 9A9ad400 onward. See the complete SBD connection list for every pin, electrical rating and application-specific function. Earlier hardware can differ.

PinDocumented function
A001–A002Ground
A003Permanent ECU 12 V
A004–A005Switched 12 V
A008Injector D
A012Injector H
A027Injector C
A031Injector G
A046Injector B
A050Injector F
A065Injector A
A069Injector E
B088 / B096CAN 2 high / low
B089 / B097CAN high / low
B100 / B108Crank signal / return
B110–B113Ignition drives A–D