Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MBE Systems standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The 9A6 is a direct-injection ECU for four-cylinder engines; SBD developed its documented application for the Ford 1.6-litre EcoBoost. SBD also identifies twin CAN buses and wideband inputs. Direct-injector and throttle control depend on exact application and configuration. Source and identification.

Wiring and pinout

Model wiring documentation: 9A6 pinout issue F, not the 9A9 connector assignment. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.

Configuration and support

For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.

Evidence limits

Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.

Selected connector pins

The following is a partial reference for 9A6 issue F; BOM 0.1 and software f192 onward. See the complete SBD connection list for every pin, electrical rating and application-specific function. Earlier hardware can differ.

PinDocumented function
A001–A002Ground
A003Permanent ECU 12 V
A004–A005Switched 12 V
A008 / A012Direct injector A + / −
A027 / A031Direct injector C + / −
A046 / A050Direct injector B + / −
A065 / A069Direct injector D + / −
A061High-pressure fuel pump drive
B088 / B096CAN 2 high / low
B089 / B097CAN high / low
B100 / B108Crank signal / return
B110–B113Ignition drives A–D