SBD lists the 9M8 for sequential fuelling of engines up to eight cylinders using high-impedance injectors. Its product page links the 9A8 wiring sheet; verify the actual build and pin functions before wiring. Source and identification.
Wiring and pinout
Model wiring documentation: 9A8 issue F; linked from SBD’s 9M8 listing. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.
Configuration and support
For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.
Evidence limits
Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.
J2 Delphi 36-way connector — issue F
From SBD's connector list. This is the general-function column; issue F also gives an I4 staged-injector column, which must be checked for that configuration. Pin numbers identify connector cavities; consult the diagram for the view. Programmable pins depend on the installed map.
| Pin | General function |
|---|---|
| 1 | Injector D (4th to fire) |
| 2 | Water temperature |
| 3 | Air temperature |
| 4 | 5VA reference |
| 5 | 0VA |
| 6 | Power ground |
| 7 | Power ground |
| 8 | CAN low |
| 9 | CAN high |
| 10 | Permanent 12 V supply |
| 11 | Crank return |
| 12 | Crank signal |
| 13 | Switched 12 V supply |
| 14 | Injector A (1st to fire) |
| 15 | Ignition (4th to fire) |
| 16 | Programmable low-side output |
| 17 | Programmable low-side output |
| 18 | Ignition (2nd to fire) |
| 19 | Programmable input |
| 20 | Throttle position |
| 21 | MAP |
| 22 | Injector E (5th to fire) |
| 23 | Injector F (6th to fire) |
| 24 | Injector G (7th to fire) |
| 25 | Programmable input/output |
| 26 | Injector C (3rd to fire) |
| 27 | Programmable input |
| 28 | Barometric pressure |
| 29 | Lambda |
| 30 | Cam signal |
| 31 | Injector H (8th to fire) |
| 32 | Injector B (2nd to fire) |
| 33 | Programmable low-side output |
| 34 | Programmable low-side output |
| 35 | Ignition (3rd to fire) |
| 36 | Ignition (1st to fire) |