The 9A4 is a four-cylinder CAN-based fuel-injection ECU. SBD says its successor 9M4 uses the same pinout and instruction sheets. The 9A4 has one CAN bus, according to the SBD CAN setup guide. Source and identification.
Wiring and pinout
Model wiring documentation: J2 Delphi 36-way, issue F. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.
Configuration and support
For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.
Evidence limits
Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.
J2 Delphi 36-way connector — issue F
From SBD's connector list. SBD confirms this 9A4 issue F sheet is used for the 9M4. Pin numbers identify connector cavities; consult the diagram for the view. Programmable pins depend on the installed map.
| Pin | General function |
|---|---|
| 1 | Injector D (4th to fire) |
| 2 | Water temperature |
| 3 | Air temperature |
| 4 | 5VA reference |
| 5 | 0VA |
| 6 | Power ground |
| 7 | Power ground |
| 8 | CAN low |
| 9 | CAN high |
| 10 | Permanent 12 V supply |
| 11 | Crank return |
| 12 | Crank signal |
| 13 | Switched 12 V supply |
| 14 | Injector A (1st to fire) |
| 15 | Ignition D (4th to fire) |
| 16 | Programmable low-side output |
| 17 | Programmable low-side output |
| 18 | Ignition B (2nd to fire) |
| 19 | Programmable input |
| 20 | Throttle position |
| 21 | MAP |
| 22 | 5VA reference |
| 23 | 0VA |
| 24 | 0VA |
| 25 | Programmable input/output |
| 26 | Injector C (3rd to fire) |
| 27 | Programmable input |
| 28 | Barometric pressure |
| 29 | Lambda |
| 30 | Cam signal |
| 31 | Cam return |
| 32 | Injector B (2nd to fire) |
| 33 | Programmable low-side output |
| 34 | Programmable low-side output |
| 35 | Ignition C (3rd to fire) |
| 36 | Ignition A (1st to fire) |