Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MBE Systems standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The 9A8 is an earlier CAN-based MBE ECU. SBD supplies its issue F pinout and lists that diagram on its 9M8 eight-cylinder ECU product page. The 9A8 uses one CAN bus under SBD’s CAN setup guide. Source and identification.

Wiring and pinout

Model wiring documentation: 9A8 issue F. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.

Configuration and support

For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.

Evidence limits

Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.

J2 Delphi 36-way connector — issue F

From SBD's connector list. This is the general-function column; issue F also gives an I4 staged-injector column, which must be checked for that configuration. Pin numbers identify connector cavities; consult the diagram for the view. Programmable pins depend on the installed map.

PinGeneral function
1Injector D (4th to fire)
2Water temperature
3Air temperature
45VA reference
50VA
6Power ground
7Power ground
8CAN low
9CAN high
10Permanent 12 V supply
11Crank return
12Crank signal
13Switched 12 V supply
14Injector A (1st to fire)
15Ignition (4th to fire)
16Programmable low-side output
17Programmable low-side output
18Ignition (2nd to fire)
19Programmable input
20Throttle position
21MAP
22Injector E (5th to fire)
23Injector F (6th to fire)
24Injector G (7th to fire)
25Programmable input/output
26Injector C (3rd to fire)
27Programmable input
28Barometric pressure
29Lambda
30Cam signal
31Injector H (8th to fire)
32Injector B (2nd to fire)
33Programmable low-side output
34Programmable low-side output
35Ignition (3rd to fire)
36Ignition (1st to fire)