Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MBE Systems standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The 9A4 is a four-cylinder CAN-based fuel-injection ECU. SBD says its successor 9M4 uses the same pinout and instruction sheets. The 9A4 has one CAN bus, according to the SBD CAN setup guide. Source and identification.

Wiring and pinout

Model wiring documentation: J2 Delphi 36-way, issue F. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.

Configuration and support

For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.

Evidence limits

Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.