SBD lists the 9M4 for sequential fuel injection on up to four cylinders using high-impedance injectors, with four ignition and four fuel drives. It supersedes the 9A4; SBD says the 9A4 pinout and instructions are also used for the 9M4. Source and identification.
Wiring and pinout
Model wiring documentation: 9A4 issue F; SBD links this same diagram from the 9M4 product page. Check connector view, wiring harness, ECU part number and installed calibration before connecting power. Programmable input and output functions depend on the map and software.
Configuration and support
For programmable SBD-supplied ECUs, Easimap is used to inspect and change maps, subject to the interface and access of the actual ECU. Some vehicle-manufacturer supplied units are locked; SBD’s FAQ warns against attempting downloads to locked ECUs. Do not assume that a serial ECU map or harness transfers directly to a newer CAN unit.
Evidence limits
Verify the build, trigger inputs, coil-driver type and software with the supplier. Not all historic variants and pin assignments are documented here.