Overview and hardware
Syvecs S12 is a British engine-management ECU. Flagship V12/high-I/O ECU launched in 2014. Manufacturer lists 28 inputs, 24 port injector outputs, 12 ignition outputs, 3 full bridges, 8 extra PWM outputs, 4 knock, 2 EGT, 3 CAN, 121 pins and 6–26 V. Its detailed specification lists two NTK lambda interfaces, but a short summary says four; confirm with Syvecs. Direct injection requires compatible external hardware and software.
Compare the required injector, ignition, actuator and sensor channels with the hardware available on the actual ECU. Capabilities and configurable functions depend on firmware, hardware revision and calibration.
Wiring and pinout
Manufacturer S12 wiring guide and pinout. Use the guide's connector view and pin numbering and verify ECU hardware revision and configuration before wiring. Pin and input functions may vary by calibration or vehicle. Syvecs wiring index contains further example pinout files.
Vehicle-specific replacement kits use their own harness or carrier board. Consult the corresponding vehicle-specific Syvecs guide rather than assuming a generic schedule applies.
Calibration and sources
Syvecs uses SCal calibration software and provides firmware and base calibrations. Check version compatibility with the unit and preserve the existing tune before changes.