
Overview and hardware
Syvecs S7-I is a British engine-management ECU. 16 general-purpose inputs, 16 low-side outputs, 6 ignition, 2 half bridges; 1 lambda, 1 knock and 1 EGT; 94 pins. Second CAN bus was introduced in September 2020. Units purchased before January 2026 have 16 MB logging, later units 64 MB standard, 128 MB optional. Its I/O connector arrangement is shared with S7Plus, subject to application.
Compare the required injector, ignition, actuator and sensor channels with the hardware available on the actual ECU. Capabilities and configurable functions depend on firmware, hardware revision and calibration.
Wiring and pinout
Manufacturer S7-I wiring guide and pinout. Use the guide's connector view and pin numbering and verify ECU hardware revision and configuration before wiring. Pin and input functions may vary by calibration or vehicle. Syvecs wiring index contains further example pinout files.
Vehicle-specific replacement kits use their own harness or carrier board. Consult the corresponding vehicle-specific Syvecs guide rather than assuming a generic schedule applies.
Calibration and sources
Syvecs uses SCal calibration software and provides firmware and base calibrations. Check version compatibility with the unit and preserve the existing tune before changes.