Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
GEMS Performance Electronics standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None
GEMS EM80
GEMS EM80 product image. Source: GEMS Performance Electronics; used with permission.

GEMS EM80: A compact standalone system for up to eight cylinders with gearshift, electronic throttle and high-speed logging. Manufacturer source.

Hardware and control

The manufacturer lists eight ignition and eight injector drivers, one wideband input, two CAN buses, 256 MB logging and an 80-way connector. Compare the detailed datasheet with the product page: the product page calls the half bridges 6 A, while rev 24 states 5 A; confirm ratings for the particular unit. GEMS model information.

GEMS systems use GWv4 configuration, with the required ECU definition and licence; software options and custom builds can differ. Record the label, hardware and firmware and confirm connected devices against the matching documentation. GWv4 manual.

Connector 1 pinout — 102987 rev 24

The manufacturer technical specification identifies connector 1 as the 32-position mating connector; use its drawing and cavity markings for orientation, verify current limits and shared input functions. These positions apply only to this specific model and document revision.

PinFunction in source
A1Knock input +
B1Knock input −
C1Active throttle feedback 2
D1Active throttle feedback 1
E1MAF input
F1Coolant temperature input
G1Bridge driver A+
H1Ignition coil driver 8
A2CAN 2 low
B2CAN 2 high
C2Active throttle feedback 3
D2Active throttle feedback 4
E25 V sensor supply 1
F2Sensor ground
G2Bridge driver A−
H2Ignition coil driver 7
A3CAN 1 low
B3CAN 1 high
C3MAP input
D3Lambda input 1, narrowband
E3Lambda input 2, narrowband
F3Sensor ground
G3Ignition coil driver 6
H3Ignition coil driver 5
A4Ethernet RX−
B4Ethernet RX+
C4Ethernet TX−
D4Ethernet TX+
E4Differential analogue input −
F4Differential analogue input +
G4Secondary 12 V supply / ignition switch
H4Power return

The 48-way connector 2, complete electrical notes and drawings remain in the linked original. Some functions can be reassigned or shared; match the actual hardware and calibration.

Further references

Sources reviewed 17 November 2026.