Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Engine ECU
Parent
Speeduino standalone ECUs
Applies to
Speeduino standalone ECUs
Tool groups
None
Manufacturers
None

The project NA6 plug-in replaces the factory 48-pin ECU on 1.6-litre NA cars from 1989–1993 and some 1.6-litre vehicles up to 1995. Check the original two-plug connector and vehicle wiring; year alone does not establish compatibility.

Installation and pinout source

The stock airflow meter is not operated by Speeduino. The project recommends a manifold-pressure connection, variable TPS and suitable intake-air-temperature sensor. Its guide states that the ST_SIG fuse must be removed for the documented stock fuel-pump control method. Consult the NA6-specific installation and wiring guide before powering the ECU. The official NA6 PCB files identify board revisions. The 48-pin car connector is not the universal v0.4 IDC connector.

Confirm exact assembled revision, modifications, controller and firmware before wiring. Sensor conditioning and compatible drivers matter; see project hardware requirements.