Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Motorsport Electronics standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The manufacturer's ME documentation identifies ME300 as an ignition-only variant of the ME442 family: the fuel-control functions in the shared software manual do not apply. The examined source does not establish a complete ME300-specific connector assignment, so obtain its exact hardware and loom documentation before wiring. Manufacturer documentation · ME manuals and downloads.

Identification and configuration

Record the complete model label, serial number, hardware generation, firmware and harness. Wire-in ECUs and vehicle-specific plug-in versions have different physical connections. Software and output assignments depend on the unit and calibration; follow the appropriate manufacturer wiring guide and check the installed configuration.

Wiring and software

A verified ME300-specific pinout was not found in the reviewed material. Do not apply the ME442 table by assumption. See ME's shared manual introduction and support and software downloads; supply the unit serial and firmware when requesting details.

Software and further information

ME provides MEITE / EZ Tune, firmware and installation guides on its support page. Confirm the software and firmware required by the actual unit. See Motorsport Electronics ECU family.

Sources reviewed 17 November 2026.