Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
AEM Performance Electronics standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None
AEM Infinity family ECU marketing image
AEM Infinity ECU family illustration, showing multiple models; not necessarily Infinity 508. Image: AEM / Holley, reproduced with permission.

AEM Infinity 508 (manufacturer part 30-7108 / 30-7112) is a programmable Infinity engine-management ECU, a separately identified model in AEM's hardware comparison.

Identification and capability

Manufacturer specificationInfinity 508
Maximum cylinders, as listed8
Sequential injector outputs8 high-impedance
Ignition8 logic-level
Connector positions80
Electronic throttleSingle
CAN channels2
Internal wideband channels1

Compare injector impedance and ignition driver type before connecting components. Maximum cylinder count does not imply every feature or configuration is available simultaneously; verify exact part number, harness and calibration. AEM lists InfinityTuner software separately from Series 1/2 EMS software.

Connector and wiring

AEM's Infinity 508 family hardware and wiring reference gives electrical limits and connector diagrams. Match the ECU's number and physical harness, and verify connector orientation. The 506 and 508 share an 80-way shell but some pin assignments differ; Series 3 and Series 7 use different connectors and are not interchangeable by name.

Example connector differences

For the specific Nissan SR20DET PNP harness documented by AEM, C1-3 and C1-4 are injector outputs 7 and 8; C1-10 is permanent battery power and C1-11 through C1-14 are ignition coil signals 4, 3, 2, 1. The source says C1-10 must be powered before ignition is switched on and that the coil signals cannot drive a coil primary directly. These are ECU connector functions in the 30-3517 application-specific wiring guide, not a universal factory vehicle pinout.

Further documents

Sources reviewed 17 November 2026. Availability of an exact part or application should be checked separately.

AEM formerly called 30-7108 the Infinity-8h. AEM model-name change announcement.