Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Emtron standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Emtron SL4 is a programmable standalone ECU from Emtron Australia. Four injector and four ignition channels are listed; the SL platform has two 34-way connectors, Ethernet communication and up to 32 MB internal logging. Emtron SL4 datasheet.

Identification and configuration

Record the ECU model, serial, board revision and loaded firmware. The Emtune calibration determines the use of configurable inputs and outputs; electrical limits, ignition driver type, injector impedance and wired supplies must be checked for the actual unit. Emtron engine-management manual.

Connector pinouts

These tables reproduce the positions in Emtron's SL4 pinout. The source diagrams are viewed looking into the ECU connector. NC is the manufacturer's unconnected designation. Verify connector keying, revision, power, grounds and all limits in the original before wiring; assignments differ between models and hardware revisions.

Connector A

PinChannel NamePinChannel Name
A1Injection Channel 1A18Auxiliary Output 9
A2Injection Channel 2A19Auxiliary Output 10
A3Injection Channel 3A20Digital Input 1
A4Injection Channel 4A21Digital Input 2
A5NCA22Digital Input 3
A6NCA23Digital Input 4
A7NCA24Digital Input 5
A8NCA25Digital Input 6
A9Sensor Supply 8VA26Ignition Channel 1
A10Auxiliary Output 1A27Ignition Channel 2
A11Auxiliary Output 2A28Ignition Channel 3
A12Auxiliary Output 3A29Ignition Channel 4
A13Auxiliary Output 4A30NC
A14Auxiliary Output 5A31NC
A15Auxiliary Output 6A32NC
A16Auxiliary Output 7A33NC
A17Auxiliary Output 8A34Auxiliary Output 9-10, 14V Supply

Connector B

PinChannel NamePinChannel Name
B1ECU 14V SupplyB18ECU Ground
B2Sensor Supply Vref1: 5.0VB19Analog Input Channel 6
B3EFI Relay Output (Low Side 200mA)B20Analog Input Channel 7
B4Ignition Switch InputB21Analog Input Channel 8
B5Crank Index Sensor +B22Analog Input Channel 9
B6Crank Index Sensor -B23Analog Input Channel 10
B7Sync Sensor +B24Knock 2 +
B8Sync Sensor -B25Knock 2 -
B9Shield (Crank/Sync/ Knock)B26ECU Ground
B10Analog Sensor 0V ReferenceB27CAN 1H
B11Analog Input Channel 1B28CAN 1L
B12Analog Input Channel 2B29NC
B13Analog Input Channel 3B30NC
B14Analog Input Channel 4B31Ethernet Tx +
B15Analog Input Channel 5B32Ethernet Tx -
B16Knock 1 +B33Ethernet Rx +
B17Knock 1 -B34Ethernet Rx -

Sensor 0 V references and main ECU grounds have distinct wiring requirements. H-bridge supplies and relay control require the installation described in the manufacturer's power-distribution guide. See Emtron wiring index and revision-specific diagrams.

Documentation and setup