Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Omex standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The older OMEM500 controls fuel injection and ignition and is mapped with MAP2000. Its hardware manual describes throttle or MAP load sensing, narrowband oxygen feedback, crank or distributor sensing, and an auxiliary low-side output selectable for a fuel-pump relay, tachometer or shift light. It describes high-impedance injectors or appropriately ballasted low-impedance injectors. Model-specific Omex manual · Omex engine-management range.

Connector and pinout

The OMEM500 hardware manual v3.02 contains model-specific ECU connector pinouts in section 13.3 and wiring diagrams in section 13.4. Use that table and the loom connector orientation for this exact model. Open the exact-model installation or hardware manual.

OMEM500 15-way loom connector

Source: Omex OMEM500 hardware manual v3.02, section 13.3, page 29. The manual gives the view at the loom connector; confirm numbering and orientation from its drawing. Wiring colours identify the documented loom and must be checked on modified installations.

PinWireFunction
1YellowIgnition driver 2
2Screened redTiming pickup input
3BlueAuxiliary output
4OrangeThrottle position wiper
5Pink5 V sensor supply
6BrownInjector driver 1
7Green/whiteAir temperature
8VioletIgnition driver 1
9WhiteInjector driver 2
10Orange/whiteLambda input
11Green/blueCoolant temperature
12GreenMAP input
13GreySensor returns
14RedPower input
15BlackPower return

Software and setup

The historical manual specifies MAP2000; software and communication requirements depend on the hardware and firmware. Record ECU serial and firmware, save the existing calibration, and confirm crank trigger, injector, coil, sensors and assigned outputs against the matching manual. Manufacturer startup calibrations require verification and adjustment for the actual engine.

Compare models and historical identities in the Omex family guide.