Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
DTAFast standalone engine management
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None
DTAFast T8 Plus engine management unit
Manufacturer product photograph: DTAFast. Permission to republish confirmed by the user.

DTAFast T8+ is a programmable T-series engine ECU. Up to eight cylinders fully sequential or 12 in semi-sequential mode. Dual drive-by-wire, dual wideband, dual variable cam control, knock control and paddle-shift support. Manufacturer specification and product photographs.

Control and software

DTAFast describes configurable inputs and outputs, Bosch wideband control, on-board logging, and a trigger oscilloscope in T-Series PC software. Capabilities, logging rates and pin usage vary by unit and firmware; confirm the exact installation and ECU specification. Product details.

Connector pinout and wiring

Use the T8+ manufacturer wiring diagram for numbered connector cavities, diagram orientation, switched and permanent supplies, grounds, actuators, sensors and hardware-revision notes. Outputs can be configurable: confirm assignments and limits in both the diagram and actual calibration. The similarly named non-plus ECU has its own separate pinout.

Identification

Record the exact model suffix, hardware revision, firmware, serial and harness before modifying wiring or calibration. Obtain software and manuals from DTAFast and see the DTAFast family reference for related models and legacy controllers.