Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
SCS Delta standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None
SCS Delta GDI4 ECU
SCS Delta GDI4 ECU. Image: SCS Delta SXTune hardware reference; reproduced with permission.

SCS Delta GDI4 is a programmable SCS Delta engine-management controller. Legacy GDI4 direct-injection controller with AMPSeal A 776164-1 and B 776163-5. The documented hardware provides four paired high- and low-side injector connections, electronic throttle, pump control, knock inputs and additional PWM/relay outputs. SCS lists it as a legacy unit; do not substitute the GDI6 pinout. SXTune GDI4 hardware reference.

Pinout and connector identification

Connector B B1–B4 are injector 1–4 high side and B13–B16 injector 1–4 low side. B5–B6 are throttle motor, and B7–B8 are fuel-pump drive in the documented configuration. The complete GDI4 connector pinout identifies every pin, its electrical description and the diagram. Numbering is model-specific; verify the connector view, supply fuses and the calibration. Adjacent models can use the same connector family with different functions.

Calibration and installation

Record hardware identity, firmware and the existing calibration. The SXTune documentation covers crank and cam setup, sensor configuration, electronic throttle, output testing, data logging and CAN. Capabilities depend on the exact unit and firmware; the presence of a menu in shared software does not establish hardware support. Match sensors, coil and injector drivers and fuse values to the original model documentation before applying power.

See SCS Delta family guide, the manufacturer legacy upgrade notes and the wiring index.