Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
SCS Delta standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None
SCS Delta 800 ECU
SCS Delta 800 ECU. Image: SCS Delta SXTune hardware reference; reproduced with permission.

SCS Delta 800 is a programmable SCS Delta engine-management controller. Legacy SCS Delta controller documented with two AMPSeal connectors A 776164-1 and B 776163-4 plus female DB9 CAN connector. The manufacturer pinout shows two H-bridge throttle motor pairs and positions for eight injector and eight ignition outputs, subject to software configuration and output ratings. SXTune 800 hardware reference.

Pinout and connector identification

A1 battery, A2 switched ignition, A3 power ground, A4–A7 injector 1–4, A9 crank and A10 cam 1. On B, B1–B4 are the two H-bridge throttle motor pairs; B9–B10 are injector 7–8 and B13–B16 ignition 5–8. The complete 800 connector pinout identifies every pin, its electrical description and the diagram. Numbering is model-specific; verify the connector view, supply fuses and the calibration. Adjacent models can use the same connector family with different functions.

Calibration and installation

Record hardware identity, firmware and the existing calibration. The SXTune documentation covers crank and cam setup, sensor configuration, electronic throttle, output testing, data logging and CAN. Capabilities depend on the exact unit and firmware; the presence of a menu in shared software does not establish hardware support. Match sensors, coil and injector drivers and fuse values to the original model documentation before applying power.

See SCS Delta family guide, the manufacturer legacy upgrade notes and the wiring index.