Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MaxxECU standalone engine management
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

MaxxECU V1 — Discontinued first-generation MaxxECU, superseded by RACE according to the manufacturer. MaxxECU product information.

MaxxECU V1
MaxxECU V1, manufacturer product image: MaxxECU. Used with permission.

Model identification and capabilities

V1 has eight peak-and-hold injector outputs and eight ignition outputs, supporting up to eight sequential cylinders or twelve with wasted spark. The manufacturer lists eight EGT inputs, built-in wideband and a 400 kPa MAP sensor. Rev 6 raised injector output capability; Rev 7 added logging and digital-input changes; Rev 9 added LSU 4.9 support. Manufacturer specification; MaxxECU model comparison.

Sequential cylinders, maximum8
Injector outputs8 peak-and-hold
Ignition outputs8
ConfigurationMTune; check the release appropriate to the ECU and hardware revision

Identification and installation

The V1 wiring archive includes separate REV5+ and REV9+ documents. Identify the actual hardware revision before choosing a connector diagram or wideband sensor; do not assume a RACE replacement has identical wiring.

Record the model label, serial number, hardware revision, firmware, connector keying and loom. Outputs can be assigned or share functions; supported functions also depend on available I/O and software configuration. The figure in the comparison is a controller capability, not proof of compatibility with a particular engine or vehicle.

Connector and pinout

Complete 48-way connector 1 positions from the manufacturer’s model-specific column. A dash in the source is shown as not assigned. Consult the drawing for orientation and the remaining connectors. Exact wiring and connector reference.

PositionManufacturer functionNotes
A1GPO 5
A2IGN 1
A3IGN 2
A4GPO 8/TACHO660ohm pullup
B1GPO 6
B2IGN 3
B3IGN 4
B4GPO 1
C1GPO 7
C2IGN 5
C3IGN 6
C4GPO 2
D1WBO2 Heater-
D2IGN 7
D3IGN 8
D4GPO 3
E1CAN H
E2CAN L
E3GND Shield
E4GPO 4
F1CLT
F2IAT
F3WBO2 VREF
F4WBO2 VS
G1+5V sensor supply(peak 0.5A, max 150mA)
G2TPS/AIN
G3WBO2 IP
G4WBO2 RCAL
H1Sensor GND
H2Trigger GND
H3TRIGGER
H4HOME
J1AIN 1 (Temperature)
J2AIN 2 (Temperature)
J3AIN 3 (0-5V)
J4AIN 4 (0-5V)
K1INJ 1
K2INJ 2
K3DIN/VR 1
K4DIN/VR 2
L1INJ 8
L2INJ 7
L3INJ 6
L4Engine GND
M1INJ 3
M2INJ 4
M3INJ 5
M4+12V ECU power supply

Consult the full diagram for wiring, grounds, supply fuses, driver limits, connector orientation and remaining positions. Sensor grounds and power grounds have different purposes; follow the matching manual.

Software and further documents

Sources reviewed 17 November 2026.