Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MaxxECU standalone engine management
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

MaxxECU STREET — Wire-in unit for up to six sequential cylinders, or up to twelve cylinders with wasted spark. MaxxECU product information.

MaxxECU STREET
MaxxECU STREET, manufacturer product image: MaxxECU. Used with permission.

Model identification and capabilities

STREET includes a 400 kPa absolute MAP sensor, an internal controller for an LSU 4.2 or 4.9 wideband sensor, two VR/digital trigger inputs, extra temperature and analogue inputs, and USB tuning. Internal logging is listed as 8 MB. Unlike SPORT, its six injector channels are high-impedance outputs and it has no built-in electronic throttle motor driver. Manufacturer specification; MaxxECU model comparison.

Sequential cylinders, maximum6
Injector outputs6 high-impedance
Ignition outputs6
ConfigurationMTune; check the release appropriate to the ECU and hardware revision

Identification and installation

The manufacturer requires external current limiting with low-impedance injectors. Connector 1 is shared in shape with other models, but some positions have different functions.

Record the model label, serial number, hardware revision, firmware, connector keying and loom. Outputs can be assigned or share functions; supported functions also depend on available I/O and software configuration. The figure in the comparison is a controller capability, not proof of compatibility with a particular engine or vehicle.

Connector and pinout

Complete 48-way connector 1 positions from the manufacturer’s model-specific column. A dash in the source is shown as not assigned. Consult the drawing for orientation and the remaining connectors. Exact wiring and connector reference.

PositionManufacturer functionNotes
A1Not assigned in source
A2IGN 1
A3IGN 2
A4GPO 8/TACHO660ohm pullup
B1Not assigned in source
B2IGN 3
B3IGN 4
B4GPO 1
C1Not assigned in source
C2IGN 5
C3IGN 6
C4GPO 2
D1WBO2 Heater-
D2Not assigned in source
D3Not assigned in source
D4GPO 3
E1CAN H
E2CAN L
E3GND Shield
E4Not assigned in source
F1CLT
F2IAT
F3WBO2 VREF
F4WBO2 VS
G1+5V sensor supply(peak 0.5A, max 150mA)
G2TPS/AIN
G3WBO2 IP
G4WBO2 RCAL
H1Sensor GND
H2Trigger GND
H3TRIGGER
H4HOME
J1AIN 1 (temperature)
J2AIN 2 (Temperature)
J3AIN 3 (0-5V)
J4AIN 4 (0-5V)
K1INJ 1
K2INJ 2
K3DIN 1
K4DIN 2
L1Not assigned in source
L2Not assigned in source
L3INJ 6
L4Engine GND
M1INJ 3
M2INJ 4
M3INJ 5
M4+12V ECU power supply

Consult the full diagram for wiring, grounds, supply fuses, driver limits, connector orientation and remaining positions. Sensor grounds and power grounds have different purposes; follow the matching manual.

Software and further documents

Sources reviewed 17 November 2026.