Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MaxxECU standalone engine management
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

MaxxECU GEN2 TRACK — New-generation ECU for up to eight sequential cylinders, with IP68-rated enclosure and dual wideband and knock inputs. MaxxECU product information.

MaxxECU GEN2 TRACK
MaxxECU GEN2 TRACK, manufacturer product image: MaxxECU. Used with permission.

Model identification and capabilities

TRACK has eight peak-and-hold injector/GP outputs, eight selectable ignition/GP outputs, 16 analogue inputs and six VR/Hall pulse inputs. The manufacturer specifies dual CAN, a 550 kPa absolute MAP sensor, Wi-Fi, Bluetooth and USB-C. It lists support for LSU 5.2, 4.9 and 4.2 sensors. Manufacturer specification; MaxxECU model comparison.

Sequential cylinders, maximum8
Injector outputs8 peak-and-hold
Ignition outputs8 selectable ignition/GP
ConfigurationMTune; check the release appropriate to the ECU and hardware revision

Identification and installation

GEN2 connector numbers and assignments are not the GEN1 RACE pinout. TRACK differs from GEN2 RACE at several MX3 positions, including CAN 2 and pulse inputs; use the TRACK column.

Record the model label, serial number, hardware revision, firmware, connector keying and loom. Outputs can be assigned or share functions; supported functions also depend on available I/O and software configuration. The figure in the comparison is a controller capability, not proof of compatibility with a particular engine or vehicle.

Connector and pinout

Selected GEN2 TRACK MX3 positions. The manufacturer’s table uses a separate TRACK column; consult the full diagram for connector orientation and remaining positions. These positions are manufacturer-labelled ECU functions, not an assurance that a particular loom or calibration uses them. Exact wiring and connector reference.

PositionFunction
3Ignition 7
4Ignition 8
9Engine ground
10Wideband 2 VS
11Wideband 2 COM/VREF
12GPO 8 / wideband 2 heater negative
18Wideband 2 RCAL
19Wideband 2 IP
20Wideband 2 heater positive 12 V
21–23Pulse input 5 signal +, signal −, shield
24CAN 2 low
25CAN 2 high
26–28Pulse input 6 signal +, signal −, shield
29–30Injector 7, injector 8 respectively

Consult the full diagram for wiring, grounds, supply fuses, driver limits, connector orientation and remaining positions. Sensor grounds and power grounds have different purposes; follow the matching manual.

Software and further documents

Sources reviewed 17 November 2026.