Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MaxxECU standalone engine management
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

MaxxECU PRO — High-channel-count GEN1 ECU for up to twelve sequential cylinders, with sixteen injector drivers and twelve ignition outputs. MaxxECU product information.

MaxxECU PRO
MaxxECU PRO, manufacturer product image: MaxxECU. Used with permission.

Model identification and capabilities

The manufacturer lists 16 peak-and-hold injector outputs, dual wideband LSU 4.2/4.9 support, 12 type K/N EGT inputs, 16 extra 0–5 V inputs, six extra temperature inputs and dual electronic-throttle capability. Its built-in MAP sensor is rated 400 kPa absolute; Bluetooth, USB and CAN are provided. Manufacturer specification; MaxxECU model comparison.

Sequential cylinders, maximum12
Injector outputs16 peak-and-hold
Ignition outputs12
ConfigurationMTune; check the release appropriate to the ECU and hardware revision

Identification and installation

Connector 4 has revision-dependent knock and sensor-ground assignments: MaxxECU documents knock inputs on REV10+ and different ground assignments on earlier units. Verify the serial and exact revision before connecting.

Record the model label, serial number, hardware revision, firmware, connector keying and loom. Outputs can be assigned or share functions; supported functions also depend on available I/O and software configuration. The figure in the comparison is a controller capability, not proof of compatibility with a particular engine or vehicle.

Connector and pinout

Selected connector 1 positions shared in the manufacturer’s GEN1 table; consult the PRO column and all connector diagrams for full details. These positions are manufacturer-labelled ECU functions, not an assurance that a particular loom or calibration uses them. Exact wiring and connector reference.

PositionFunction
A2Ignition 1
A3Ignition 2
A4GPO 8 / tacho
B2Ignition 3
B3Ignition 4
B4GPO 1
C2Ignition 5
C3Ignition 6
C4GPO 2
D1Wideband heater negative
D4GPO 3
E1CAN high
E2CAN low
E3Shield ground
F1Coolant temperature
F2Air temperature
F3Wideband VREF
F4Wideband VS

Consult the full diagram for wiring, grounds, supply fuses, driver limits, connector orientation and remaining positions. Sensor grounds and power grounds have different purposes; follow the matching manual.

Software and further documents

Sources reviewed 17 November 2026.