Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MaxxECU standalone engine management
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

MaxxECU SPORT — Six-cylinder sequential wire-in ECU with peak-and-hold injection and electronic-throttle outputs. MaxxECU product information.

MaxxECU SPORT
MaxxECU SPORT, manufacturer product image: MaxxECU. Used with permission.

Model identification and capabilities

SPORT has six peak-and-hold injector outputs, six ignition outputs, seven general ground outputs and two motor outputs. Inputs include two trigger inputs, two extra temperatures, six extra 0–5 V inputs, two digital inputs, an internal 400 kPa MAP sensor and a wideband controller for LSU 4.2/4.9. Its product page describes Bluetooth for MDash and USB for MTune. Manufacturer specification; MaxxECU model comparison.

Sequential cylinders, maximum6
Injector outputs6 peak-and-hold
Ignition outputs6
ConfigurationMTune; check the release appropriate to the ECU and hardware revision

Identification and installation

SPORT has different assignments from STREET and V1 on several positions of connector 1. Verify both connector columns and ECU revision; 5 V ignition signals require a suitable igniter or smart coil.

Record the model label, serial number, hardware revision, firmware, connector keying and loom. Outputs can be assigned or share functions; supported functions also depend on available I/O and software configuration. The figure in the comparison is a controller capability, not proof of compatibility with a particular engine or vehicle.

Connector and pinout

Selected 48-way connector 1 positions; these are shared in the manufacturer’s comparison. Consult the SPORT column for all positions and the physical view. These positions are manufacturer-labelled ECU functions, not an assurance that a particular loom or calibration uses them. Exact wiring and connector reference.

PositionFunction
A2Ignition 1
A3Ignition 2
A4GPO 8 / tacho
B2Ignition 3
B3Ignition 4
B4GPO 1
C2Ignition 5
C3Ignition 6
C4GPO 2
D1Wideband heater negative
D4GPO 3
E1CAN high
E2CAN low
E3Shield ground
F1Coolant temperature
F2Air temperature
F3Wideband VREF
F4Wideband VS

Consult the full diagram for wiring, grounds, supply fuses, driver limits, connector orientation and remaining positions. Sensor grounds and power grounds have different purposes; follow the matching manual.

Software and further documents

Sources reviewed 17 November 2026.