Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MaxxECU standalone engine management
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

MaxxECU RACE — Eight-cylinder sequential ECU with eight peak-and-hold injectors, electronic throttle, knock inputs and eight thermocouple inputs. MaxxECU product information.

MaxxECU RACE
MaxxECU RACE, manufacturer product image: MaxxECU. Used with permission.

Model identification and capabilities

The manufacturer lists eight ignition outputs, nine low-driving auxiliary outputs, two 12 V driving outputs and four motor outputs. Built-in features include a 400 kPa MAP sensor, wideband lambda controller and two knock inputs. Up to twelve cylinders can be controlled with wasted-spark ignition, depending on configuration. Manufacturer specification; MaxxECU model comparison.

Sequential cylinders, maximum8
Injector outputs8 peak-and-hold
Ignition outputs8
ConfigurationMTune; check the release appropriate to the ECU and hardware revision

Identification and installation

This is the original RACE, not GEN2 RACE. Use the model and hardware revision to select the wiring diagram; the manufacturer identifies RACE H2O as a separate water-protected version.

Record the model label, serial number, hardware revision, firmware, connector keying and loom. Outputs can be assigned or share functions; supported functions also depend on available I/O and software configuration. The figure in the comparison is a controller capability, not proof of compatibility with a particular engine or vehicle.

Connector and pinout

Selected 48-way connector 1 positions common to the manufacturer’s V1/RACE/PRO, STREET and SPORT columns; use the RACE diagram for complete wiring and connector orientation. These positions are manufacturer-labelled ECU functions, not an assurance that a particular loom or calibration uses them. Exact wiring and connector reference.

PositionFunction
A2Ignition 1
A3Ignition 2
A4GPO 8 / tacho
B2Ignition 3
B3Ignition 4
B4GPO 1
C2Ignition 5
C3Ignition 6
C4GPO 2
D1Wideband heater negative
D4GPO 3
E1CAN high
E2CAN low
E3Shield ground
F1Coolant temperature
F2Air temperature
F3Wideband VREF
F4Wideband VS

Consult the full diagram for wiring, grounds, supply fuses, driver limits, connector orientation and remaining positions. Sensor grounds and power grounds have different purposes; follow the matching manual.

Software and further documents

Sources reviewed 17 November 2026.