Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
MaxxECU standalone engine management
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

MaxxECU MINI — Compact entry ECU with four injector and four ignition outputs; up to four fully sequential cylinders or eight in wasted spark. MaxxECU product information.

MaxxECU MINI
MaxxECU MINI, manufacturer product image: MaxxECU. Used with permission.

Model identification and capabilities

A 400 kPa absolute MAP sensor is built in. The MINI has one VR/Hall trigger, two extra Hall/digital inputs and two extra 0–5 V analogue inputs in addition to its named temperature and throttle inputs. The manufacturer specifies four auxiliary outputs and 8 MB of internal logging, up to 1000 Hz. CAN and USB are available. Manufacturer specification; MaxxECU model comparison.

Sequential cylinders, maximum4
Injector outputs4 high-impedance
Ignition outputs4
ConfigurationMTune; check the release appropriate to the ECU and hardware revision

Identification and installation

It does not include an internal wideband controller: use the documented external analogue or CAN solution. Injector outputs are intended for high-impedance injectors; observe the manufacturer’s instructions for low-impedance injectors and external current limiting.

Record the model label, serial number, hardware revision, firmware, connector keying and loom. Outputs can be assigned or share functions; supported functions also depend on available I/O and software configuration. The figure in the comparison is a controller capability, not proof of compatibility with a particular engine or vehicle.

Connector and pinout

MINI connector 1, REV10+; see the linked manufacturer drawing for the connector face and its cavity positions. These positions are manufacturer-labelled ECU functions, not an assurance that a particular loom or calibration uses them. Exact wiring and connector reference.

PositionFunction
A1Trigger
A2Trigger ground
B1Digital input 1
B2Digital input 2
B3, B4Sensor ground
C1Coolant temperature
C2Air temperature
C3, C4Analogue 3, 4 respectively
D1GPO 8 / tachometer
D2Throttle position
D3Shield
D4Sensor ground
E1GPO 3
E25 V sensor supply
E3CAN low
E4CAN high
F1–F4Ignition 1–4 respectively
G1GPO 2
G2GPO 1
G3Injector 1
G4Engine ground
H1–H3Injector 2–4 respectively
H412 V ECU supply

Consult the full diagram for wiring, grounds, supply fuses, driver limits, connector orientation and remaining positions. Sensor grounds and power grounds have different purposes; follow the matching manual.

Software and further documents

Sources reviewed 17 November 2026.