Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Emerald standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Emerald K6 is a 32-bit programmable engine-management ECU introduced in early 2010. Emerald specifies six injection and six ignition drivers, allowing sequential control for up to six cylinders. Emerald K6 specification.

Inputs, outputs and interfaces

  • Three configurable inductive or digital speed-trigger inputs for crank, cam or distributor.
  • Internal barometric pressure sensor; engine load by TPS and/or 0–5 V MAP signal.
  • Six injector drivers and six configurable ignition drivers. The manufacturer's page describes active-high use with external amplifiers or active-low direct coil control.
  • RS232 communication and CAN 2.0B up to 1 Mbit/s; up to four road-speed inputs.
  • Adaptive lambda uses a suitable external wideband controller with 0–5 V output; K6 also accepts a narrowband signal.

Emerald's specification gives a 6.5–18 V operating supply, 110 × 190 × 44 mm case, IP65 enclosure and IP68 connectors. Features and pins must be checked against the actual hardware and configuration.

Wiring and identification

Obtain the K6 quick-start, configuration guide and K3/K6 manual from Emerald's software and manuals page. Emerald also supplies vehicle-specific adapters; those adapters do not make every factory harness interchangeable. The manufacturer notes that individual units can have bespoke software, so quote the serial number when in doubt.

See Emerald standalone ECUs and the separate K6+ reference.