Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Omex standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The 710 is Omex's programmable fuel-and-ignition ECU for a broad range of two- to twelve-cylinder configurations. The manufacturer lists distributor, wasted-spark and individual-coil ignition arrangements, two-stage and compatible continuous cam control, staged injectors, boost control, launch and flat shift. Features and outputs depend on firmware, hardware and engine configuration. Model-specific Omex manual · Omex engine-management range.

Connector and pinout

The Omex 710 hardware manual 2v11 gives connector pins at page 66 and wiring from page 68. FUEL outputs can be allocated as injection or PWM outputs, while some IGN outputs have configurable alternatives. Verify output allocation, driver capability and actual loom before wiring. Open the exact-model installation or hardware manual.

Software and setup

Omex lists MAP4000 for its current ECU range; check the exact unit, firmware and communications lead before attempting to connect. Record ECU serial and firmware, save the existing calibration, and confirm crank trigger, injector, coil, sensors and assigned outputs against the matching manual. Manufacturer startup calibrations require verification and adjustment for the actual engine.

Compare models and historical identities in the Omex family guide. Omex 710 product details.