The historical OMEM550 controls injection and ignition and uses MAP2000. Manual v3.02 describes throttle-position or manifold-pressure load input, air and coolant temperature sensors, narrowband oxygen feedback, a configurable auxiliary output and fuel and ignition maps. The manual documents crank trigger and distributor-trigger options; identify the sensor and programmed timing configuration. Model-specific Omex manual · Omex engine-management range.
Connector and pinout
The OMEM550 hardware manual v3.02 gives its model-specific ECU pinout in section 13.3 and wiring diagrams in section 13.4. Do not assume that a 500 or 600 loom is interchangeable. Open the exact-model installation or hardware manual.
Software and setup
The historical manual specifies MAP2000; software and communication requirements depend on the hardware and firmware. Record ECU serial and firmware, save the existing calibration, and confirm crank trigger, injector, coil, sensors and assigned outputs against the matching manual. Manufacturer startup calibrations require verification and adjustment for the actual engine.
Compare models and historical identities in the Omex family guide.