Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Omex standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The 200 is an ignition-only ECU rather than a full fuel-injection controller. Its installation manual identifies two amplified ignition outputs for single-coil/distributor or wasted-spark configurations. It describes inputs for crank position, throttle, temperature and MAP, as well as relay-controlled fuel pump and fan functions. Individual hardware modifications may be necessary for particular coil-on-plug arrangements. Model-specific Omex manual · Omex engine-management range.

Connector and pinout

The exact loom-side connector table and diagrams are in section 4.3 of Omex installation manual 2v10. The guide identifies FTG input at 10A; do not transfer the 600 pinout to a 200. Open the exact-model installation or hardware manual.

Software and setup

Omex lists MAP4000 for its current ECU range; check the exact unit, firmware and communications lead before attempting to connect. Record ECU serial and firmware, save the existing calibration, and confirm crank trigger, injector, coil, sensors and assigned outputs against the matching manual. Manufacturer startup calibrations require verification and adjustment for the actual engine.

Compare models and historical identities in the Omex family guide.