Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
SCS Delta standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None
SCS Delta 400 ECU product brochure
Delta 400. Image: Specialist Control Systems; source: SCS Delta ECU range. Reproduced with permission.

SCS Delta 400 is a programmable SCS Delta engine-management controller. A 35-way AMPSeal 776164-1 main connector; the reference describes four low-side injector outputs and four ignition outputs in its normal application. Pins A23 and A29 are multifunction low-side outputs. SCS describes it as a plug-in upgrade for certain Typhoon and Storm-family units, but firmware and exact replacement conditions must be confirmed. SXTune 400 hardware reference.

Pinout and connector identification

A1 battery supply; A2 ignition switched supply; A3 power ground; A4–A7 injector 1–4; A8 crank/cam ground; A9 crank; A10 cam 1; A11 coolant; A12 air temperature; A13–A16 ignition 1–4. The complete 400 connector pinout identifies every pin, its electrical description and the diagram. Numbering is model-specific; verify the connector view, supply fuses and the calibration. Adjacent models can use the same connector family with different functions.

Delta 400 connector A pinout

For Delta 400 only, connector A AMPSeal 776164-1. Refer to the manufacturer's Delta 400 pinout for diagram, terminals, current limits, fuse values and connection orientation. Functions shown include the manufacturer's typical assignments; configurable inputs and outputs depend on calibration.

PinFunction
A1Battery supply
A2Ignition switched supply
A3Power ground 1
A4Low side output 1 / injector 1
A5Low side output 2 / injector 2
A6Low side output 3 / injector 3
A7Low side output 4 / injector 4
A8Crank/cam sensor ground
A9Crank sensor
A10Cam sensor 1
A11Coolant temperature
A12Air temperature
A13Ignition 1
A14Ignition 2
A15Ignition 3
A16Ignition 4
A17Analogue input 1
A18Cam 2 / wheel speed
A19Analogue ground 1
A20Lambda 1 input
A21CAN 1 high
A22CAN 1 low
A23Low side output 5 / multifunction I/O
A24Low side output 7 / main relay, PWM 1
A25Low side output 8 / fuel pump relay, PWM 2
A26Low side output 9 / PWM 3
A27Low side output 10 / PWM 4
A28Low side output 11 / tacho
A29Low side output 6 / multifunction I/O
A30Analogue ground 2
A31NTC input 3
A32Analogue input 2 / TPS 1
A33Analogue input 3 / MAP
A345 V sensor reference
A35Power ground 2

Calibration and installation

Record hardware identity, firmware and the existing calibration. The SXTune documentation covers crank and cam setup, sensor configuration, electronic throttle, output testing, data logging and CAN. Capabilities depend on the exact unit and firmware; the presence of a menu in shared software does not establish hardware support. Match sensors, coil and injector drivers and fuse values to the original model documentation before applying power.

See SCS Delta family guide, the manufacturer legacy upgrade notes and the wiring index.