Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
ECUMaster standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Pro-8 is the smaller ECU in the EMU Pro range, aimed at up to eight-cylinder engines. ECUMaster lists eight peak-and-hold injector outputs, eight software-selectable active or passive ignition outputs, 12 low-side auxiliary outputs, three full H-bridges, two LSU 4.9 controllers, two drive-by-wire controllers, two CAN buses and one LIN bus. The IP65 enclosure measures 165 × 95 × 38 mm. Direct-injection engines need the separate GDI Driver. Manufacturer product specification · Manufacturer comparison.

Connector pinout and wiring

The linked v1.0 pinout specifies three Superseal 1.0 mating housings A 4-1437290-1, B 1473416-1 and C 4-1437290-0. CAN1 serves PC communications and requires external termination; USB is for a flash logging drive. Use the exact PDF drawings for cavity numbers, orientation and current limits. Exact-model manufacturer pinout.

Software and installation

Record the ECU serial, firmware, software and project versions and confirm assigned outputs and trigger inputs before connecting loads. The manufacturer downloads contain current software, manuals and supported base maps. Base maps do not establish the correct pinout for a particular vehicle. Compare with the ECUMaster family guide.