Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
ECUMaster standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

The universal EMU Classic is the successor to the original EMU. The manufacturer describes revised ignition outputs, a separate 5 V regulator, improved H-bridge protection and isolated USB; both share an EMU firmware and software family. Six high-impedance injector outputs and six ignition drivers are listed, with a built-in 4 bar MAP sensor, LSU 4.2 wideband controller and two EGT inputs. CAN and electronic throttle need external modules according to the manufacturer's comparison. Manufacturer product specification · Manufacturer comparison.

Connector pinout and wiring

Two FCI 24-way connectors. The black connector includes primary trigger at 7, ECU ground 17 and +5 V at 23. The grey connector has ignition coil 6 at 1, injector 1 at 7, +12 V power at 18 and power ground at 24. These positions are from the linked Classic diagram, not the Black ECU pinout. Exact-model manufacturer pinout.

Software and installation

Record the ECU serial, firmware, software and project versions and confirm assigned outputs and trigger inputs before connecting loads. The manufacturer downloads contain current software, manuals and supported base maps. Base maps do not establish the correct pinout for a particular vehicle. Compare with the ECUMaster family guide.