Feedback, learning and purge are separate states
A changing short-term lambda correction, a stored mixture adaptation and an evaporative-canister purge command answer different questions. These examples are scoped to VAG ME7.1 and ME7.5; the detailed flags below come from the Bosch Audi R4-5V turbo 132 kW ME7.1 function description, especially LREB, LRAEB, BBTEGA and TEBEB. Other software may use different conditions, names or diagnostic presentations.
In a NefMoto S4 M-box discussion, an owner described missing part-throttle adaptation after an N80-related hardware/configuration issue, then reported loss of correction after a further lambda-request change. A reply points out the limitations of that narrowband configuration. The thread does not isolate a universal fault mechanism; it illustrates why a static trim should lead to checking the control and learning states, sensor and fitted equipment rather than immediately altering injector calibration.
Signals to distinguish in the Bosch example
| Signal or state | What it means in the cited function | What it does not establish |
|---|---|---|
B_lr / B_lr2 | Pre-catalyst lambda-control enabling conditions for the respective banks, where fitted. | That long-term mixture learning is also currently enabled. |
fr_w and bank equivalents | The immediate correction factor where defined; check the logger's scale and neutral value. | A neutral or unchanged number alone proves neither disabled feedback nor a correct base calibration. |
B_gap | A mixture-adaptation phase is active. | Bosch explicitly notes that this phase flag alone does not establish that learning is actually active. |
B_lra / B_lra2, B_gasp | Bank-specific adaptation enable conditions and a grouped inhibition condition in the documented logic. | The cause of an inhibition without the underlying inputs and diagnostics. |
B_tep, B_te | Purge-phase and purge-related operating signals in the Bosch description. | A phase flag by itself proves neither valve movement nor measured vapor flow. |
These are function-description names, not guaranteed channels or addresses in a particular logger. The ME7Logger alias list includes some of them; verify availability, bank, units and definitions in the exact image. Log the actuator command and use the applicable vehicle diagnostic procedure to check its physical operation.
Why learning may wait
In the cited Bosch LRAEB example, adaptation depends on conditions including sensor feedback, a suitable mixture-learning phase, temperature and a delay after certain events. Full load, some diagnostic or transient states, purge operation and particular faults can inhibit it. Bosch also describes a temporary learning inhibit after brake operation to avoid learning from the associated air disturbance. These are conditions in that documented logic, not fixed timing values for every ME7.
BBTEGA coordinates mixture-learning and purge phases. Bosch notes that the phase flag does not guarantee that the corresponding function is actually active, and describes a controlled purge fallback when lambda control is unavailable. Compare B_lr, learning enable/inhibit, requested and measured lambda, correction and relevant purge states over time; do not conclude from one phase or one sample that a valve is flowing or an adaptation is learning.
Read a fault in context
In a 1.8T ATW discussion, participants disagreed over whether an EVAP fault necessarily froze both short- and long-term values; the owner reported that their trims appeared to work. No matched log in the available posts settles the disagreement. Check the exact software, active fault and each feedback/learning signal instead of assuming that a particular code always disables both.
For a stored P0441, Ross-Tech's diagnostic reference lists several potential purge-system causes. A valve circuit fault, a flow fault, an intake leak and a disabled or substituted diagnostic are different situations. Record faults, freeze-frame or operating conditions, sensor readiness, control and learned values before clearing or resetting anything; follow the service procedure for the fitted system.
Related: ME7 lambda control state during boost, injector changes and part-load diagnosis and misfire and lean lambda logs. Forum cases are reported observations and have not been independently vehicle-tested by this wiki.