Temperature changes more than one calculation
This guide concerns the VAG ME7.1 and ME7.5 examples in the cited sources. Identify the actual ECU, intake-temperature sensor location, pressure sensors and calibration. Intake temperature can influence charge modelling, permitted load, ignition corrections and component-protection behavior; the active paths and names vary with software.
In a NefMoto ME7.1 discussion, contributors note that for a fixed requested load the pressure required by the model can rise with intake temperature. This does not mean requested pressure always rises on a hotter day: the permitted load, other corrections and hardware limits can change at the same time.
A physical illustration
For the same ideal gas at the same density, absolute pressure is proportional to absolute temperature. At 20 °C the temperature is 293.15 K; at 40 °C it is 313.15 K. The ratio 313.15 ÷ 293.15 is about 1.068, so the warmer air would require about 6.8% more absolute pressure to retain that density in this simplified example. This is not a boost target or a complete ME7 calculation; real cylinder filling, exhaust residuals, turbo efficiency and pressure losses also matter. NASA's equation-of-state explanation uses absolute temperature for this relationship.
Use Kelvin by adding 273.15 to Celsius for this calculation. Do not substitute gauge boost for absolute pressure, or transfer an isolated formula to the ECU without its offsets, units and corrections.
Ignition and temperature
The Audi 1.8T ME7.1 function description shows a dzwwl ignition correction involving coolant temperature, load, RPM and intake temperature in its ZWWL function. A temperature-correction discussion notes that a label containing “warm-up” does not alone identify every condition or map contribution. Verify the active function and weighting in the exact software.
Colder air may provide more knock margin, but an absence of knock does not establish the timing that produces maximum torque. Compare final timing and per-cylinder corrections alongside temperature, mixture and torque intervention; do not infer a safe universal timing change from an IAT difference.
Compare runs usefully
Record the sensor location, intake and coolant temperatures, ambient pressure, RPM, load request and actual load, the corresponding pressure request and measurement, throttle, ignition and knock corrections, final lambda request and measured lambda. Compare similar gears or dyno load, cam state, fuel and adaptation state. A heat-soaked sensor, a genuine hot charge, a different load limit and a pressure-control issue can produce different-looking plots.
Related: S4 load, torque and ignition examples, spool and steady-state boost and ME7 ignition and knock reference. Forum examples are attributed reports, not independent tests by this wiki.