Separate the two fuel circuits
The AXX 2.0 FSI Turbo example in Volkswagen SSP 337, pages 17–21 has direct injectors, a low-pressure electric supply and an engine-driven high-pressure pump. Its system overview identifies low-pressure sender G410, rail-pressure sender G247, pump controller J538 and pressure-control valve N276. Low supply pressure and inadequate rail pressure are different symptoms, even though a supply problem can affect the high-pressure side. Confirm the components fitted to the vehicle being tested.
The AXX training material describes homogeneous running and two injection events during its cold-start catalyst-heating phase. That is a direct-injection operating strategy; it does not establish a separate port-injector system. Keep temperature and operating state with lambda and injector data.
A measured-block example
Ross-Tech's 2.0 TFSI AXX/BGB/BPJ/BPY/BWA fuel-pressure procedure gives the following VCDS measuring-block examples. Their stated prerequisites include engine idling, coolant at least 80 °C and system voltage at least 11 V. Verify the engine, ECU, channel labels and units in the actual diagnostic tool; these are examples, not universal channel assignments.
| Measuring block | Fields in the Ross-Tech procedure | Use |
|---|---|---|
| 103 | Field 1: low fuel pressure. | Establish whether the supply side is behaving plausibly. Ross-Tech notes that this group does not apply to the later chain-driven examples it identifies without G410. |
| 230 | Field 1: specified high rail pressure; field 2: actual high rail pressure; field 3: deviation. | Compare request and actual in the documented procedure and under the conditions supported by the equipment. |
The limits and conditions in the Ross-Tech test belong to that procedure; do not turn its idle or speed-check values into universal full-load tuning targets. When logging, record low pressure, requested and actual rail pressure, lambda request and actual, engine speed, load, temperature and any relevant fault or intervention state. Sampling speed and channel availability can limit what a log shows.
When rail pressure falls short
- Keep the original faults and freeze-frame data. If low-pressure supply faults are present, diagnose the supply, filter, lines and pump control using the appropriate service information before assuming the high-pressure pump is defective.
- Check whether the pressure shortfall is persistent, load-dependent or accompanied by a sensor, regulator or supply fault; compare lambda and injection data. Do not correct a mechanical fuel-delivery shortfall by simply changing the pressure request.
- On the particular BPY vehicles covered by Volkswagen bulletin V151401 / 2015153—2006–07 Eos, GTI and Passat, and 2005–07 Jetta A5—the manufacturer discusses cam-lobe and pump-follower wear associated with specific rail-pressure faults. The bulletin directs low-pressure faults to be diagnosed first and describes inspection under its service procedure. It is not evidence that every MED9 engine has the same failure or an inspection interval.
Use current vehicle-specific workshop instructions for fuel-system work. For the relationship between torque requests, boost and ignition, see MED9.1 torque, boost and ignition tuning. The cited VW training and service documents are hosted by independent sites and NHTSA; the guidance above has not been vehicle-tested by this wiki.